Suppression Ferrites; Connections To Other Equipment; Declaration Of Conformity; Product Disposal - Lighthouse a65 Installation And Operation Instructions Manual

The license agreements for the above can be found
on the website www.raymarine.com
accompanying documentation CD if supplied.

Suppression ferrites

Raymarine cables may be fitted with suppression
ferrites. These are important for correct EMC
performance. If a ferrite has to be removed for any
purpose (e.g. installation or maintenance), it must be
replaced in the original position before the product
is used.
Use only ferrites of the correct type, supplied by
Raymarine authorized dealers.
Where an installation requires multiple ferrites to be
added to a cable, additional cable clips should be
used to prevent stress on the connectors due to the
extra weight of the cable.

Connections to other equipment

Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected
to other equipment using a cable not supplied by
Raymarine, a suppression ferrite MUST always be
attached to the cable near the Raymarine unit.

Declaration of conformity

Raymarine UK Ltd. declares that this product is
compliant with the essential requirements of R&TTE
directive 1999/5/EC.
The original Declaration of Conformity certificate
may be viewed on the relevant product page at
www.raymarine.com.

Product disposal

Dispose of this product in accordance with the
WEEE Directive.
The Waste Electrical and Electronic Equipment
(WEEE) Directive requires the recycling of waste
electrical and electronic equipment. Whilst the
WEEE Directive does not apply to some Raymarine
products, we support its policy and ask you to be
aware of how to dispose of this product.

Pixel defect policy

In common with all TFT units, the screen may exhibit
a few wrongly-illuminated ("dead") pixels. These
may appear as black pixels in a light area of the
screen or as colored pixels in black areas.
If your display exhibits MORE than the number
of wrongly-illuminated pixels allowed (refer to the
product technical specification for details), please
contact your local Raymarine service center for
further advice.
Important information

Warranty registration

and on the
To register your Raymarine product ownership,
please visit
It is important that you register your product to
receive full warranty benefits. Your unit package
includes a bar code label indicating the serial number
of the unit. You will need this serial number when
registering your product online. You should retain
the label for future reference.

IMO and SOLAS

The equipment described within this document
is intended for use on leisure marine boats and
workboats NOT covered by International Maritime
Organization (IMO) and Safety of Life at Sea
(SOLAS) Carriage Regulations.

Technical accuracy

To the best of our knowledge, the information in this
document was correct at the time it was produced.
However, Raymarine cannot accept liability for any
inaccuracies or omissions it may contain. In addition,
our policy of continuous product improvement may
change specifications without notice. As a result,
Raymarine cannot accept liability for any differences
between the product and this document. Please
check the Raymarine website (www.raymarine.com)
to ensure you have the most up-to-date version(s) of
the documentation for your product.
www.raymarine.com and register online.
15