Radar Scanner Status Symbols - Lighthouse a65 Installation And Operation Instructions Manual

Non-HD
Digital HD
Feature Radome Radome
Gain 0-100
Preset
Tune Cor-
rection
Note: Features not listed are supported by all
types of Raymarine Non-HD Digital, HD and
SuperHD radars.
Radar application
SuperHD
HD Open Open
Array Array

20.2 Radar scanner status symbols

The radar scanner power mode status is indicated
in the databar.
Radar
power
Symbol mode
Trans-
mit (TX)
Standby
(STBY)
Off
Timed
Trans-
mit
Powering the radar scanner on and off
In the radar application:
1. Select Menu.
2. Select Power to switch the Radar's power On
and Off.
The radar will always power up in Standby mode.
3. Select Radar to switch the radar between
Transmit and Standby modes.
Using the power button to switch operating
modes
The radar operating modes can also be set using the
multifunction displays power button menu.
1. Press and release the Power button.
The shortcuts menu is displayed:
Description
Rotating icon, signifying that the
scanner is on and transmitting.
When SCANNER is set to ON,
select this mode to activate the
scanner. This is the usual mode of
operation.
Static icon, indicating that the
scanner is on but not transmitting,
and the antenna is not rotating.
The scanner does not transmit and
the radar data is removed from the
screen. This is a power-save mode
used when the radar is not needed
for short time periods. When
you return to transmit mode, the
magnetron does not need to warm
up again. This is the default mode.
Scanner powered off when radar
not required, but display is in use
for other applications, such as the
chart. When selected, the system
counts down. During this time you
cannot re-power the scanner.
Scanner switches between
on/transmitting, and standby mode.
Scanner goes into power save
mode when constant use of radar
is not required.
293