Table of Contents
Advertisement
5000
9000
1. Remove the hairpin clip from the pin
located at the front of the access
panel.
2. On the M/XF, remove the thumb
screw securing the front left access
panel to the front facia. Move the
panel up and off the pin; then swing
the panel all the way out and
unhinge the panel from the lower
console.
3. Remove the two torx-head screws
securing the hood (located on the
underside of the hood above the
front tube of the upper A-arm); then
remove the two torx-head screws
from the top-side of the hood secur-
ing the hood to the upper console
and the two torx-head screws from
under the nosepiece of the hood.
20
4. Remove the intake panel below the
gauge; then locate the hood harness
connector (located in front of the
speedometer) and unplug the con-
nector; then move the hood slightly
forward and remove the hood.
NOTE: On the 9000, first unhook the
rubber straps securing the air filter
housing to the intake plenum of the
hood; then move the hood slightly for-
0746-792
ward and remove the hood.
To install the access panel and hood, use
the following procedure:
1. Position the hood onto the snowmo-
bile and connect the hood harness
connector making sure the harness
does not become pinched.
NOTE: On the 8000, make sure the
hood tabs are seated between the
throttle body boot.
0746-091
NOTE: On the 9000 prior to secur-
ing the hood, make sure the air filter
is seated properly into the air
silencer and secured using the two
rubber straps.
2. Secure the hood with torx-head
screws and tighten securely.
NOTE: Before installing the hood,
make sure the mounting screw clips
are in position.
NOTE: On the 5000, make sure the
foam seal is in place on the air intake.
NOTE: On the 9000, make sure the
air filter housing is properly con-
nected and secured with the rubber
straps to the intake plenum of the
hood and turbocharger.
3. Install the access panel onto the lower
console; then close the access panel
0746-800
and secure with the hairpin clip and
thumb screw. Install the intake panel.
Removable Seat (5000/
ZR 8000/XF 8000/M
8000 STD/9000)
These snowmobiles are equipped with a
removable seat. To remove the seat, use
the following procedure:
Advertisement
Table of Contents
