Table of Contents
Advertisement
4. If the warning icon does not go out,
shut the engine off immediately and
repeat step 2; then repeat step 3.
If the warning icon does not go out or if
the engine does not start, take the snow-
mobile to an authorized Arctic Cat Snow-
mobile dealer. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
Indicator Icons (Deluxe
Gauge)
Certain models are equipped with a
deluxe gauge combination speedometer/
tachometer. Indicator icons are incorpo-
rated within the speedometer/tachome-
ter.
Also
incorporated
speedometer/tachometer is a digital read-
out screen.
A. High Beam
B. Oil Pressure/Low Oil
C. Coolant Temperature
D. Increment Button
E. Select Button
F. Decrement Button
G. Service
H. Charging System (5000/9000)
RPM/MPH (kph)
By pushing the increment button once,
the RPM and MPH will be displayed
(one on the readout screen and one with
the needle). By pushing the button once
again, the functions will be reversed.
By pushing the increment button (with
speed being displayed) for more than two
seconds, the display will change between
standard mph or metric kph.
10
With RPM displayed on the readout
screen by pushing and holding the incre-
ment button, maximum RPM will be dis-
played on the readout screen. The
maximum RPM readout will reset when
the decrement button is pushed (while
maximum RPM is displayed).
Odometer/Trip-Meter (1)/
Trip-Meter (2)/Hour-Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the trip
meter displayed, push and hold the decre-
ment button until the display is cleared.
The hour-meter readout will not reset.
into
the
Clock/Altimeter
By pushing the select button, the readout
screen will display clock, altimeter, and
maximum altimeter.
To set the clock, select clock on the display
by pushing and holding the select button
for two seconds; the option of selecting the
12-hour or 24-hour clock mode is avail-
able. Push the increment button to toggle
between the 12-hour display and the 24-
hour display. When desired mode is dis-
played, push the select button.
FZ001A
At this point, the hours display will begin
to flash. Push the increment button to
increase the hours; push the decrement
button to decrease the hours. Pushing and
holding a button will accelerate the num-
ber display. When desired hour number is
displayed, push the select button.
At this point, the minutes display will
begin to flash. Push the increment button
to increase the minutes; push the decre-
ment button to decrease the minutes.
Pushing and holding a button will accel-
erate the number display. When desired
minute number is displayed, push the
select button.
NOTE: During clock setting if no
button
(increment,
select) is pushed within a 5-second
time period, the clock-setting mode
will be exited with changes saved.
NOTE: The altimeter readout is
based off barometric pressure and
may require calibration as weather
conditions change.
decrement,
Advertisement
Table of Contents
