Track Alignment - Arctic Cat ZR 5000 Operator's Manual

! WARNING
Always make sure the adjusting bolts
are snug against the axle and the
idler wheel cap screws are tightened
to specifications. Failure to do so
could cause the track to become
extremely loose and, under some
operating conditions, allow the idler
wheels to climb over the track lugs
forcing the track against the tunnel
causing the track to "lock." If a track
"locks" during operation, severe per-
sonal injury could result.

Track Alignment

Proper track alignment is obtained when
the rear idler wheels are equal distance
from the inner track drive lugs. Excessive
wear to the idler wheels, drive lugs, and
track will occur if the track is improperly
aligned. Arctic Cat recommends that the
track alignment be checked once a week
or whenever the track tension is adjusted.
Checking Track Alignment
! WARNING
Make sure the ignition key is in the
OFF position and the track is not
rotating before checking or adjusting
track alignment. Personal
could result if contact is made with a
rotating track.
1. Remove excess ice and snow
buildup from the track, track drive
sprockets, and the inside of the skid
frame.
2. Position the tips of the skis against a
wall; then using a shielded safety
stand, raise the rear of the snowmo-
bile off the floor making sure the
track is free to rotate.
! WARNING
The tips of the skis must be posi-
tioned against a wall or similar
object.
! WARNING
DO NOT stand behind the snowmo-
bile or near the rotating track. NEVER
run the track at high speed when the
track is suspended.
46
3. Start the engine and accelerate
slightly. Use only enough throttle to
turn the track several revolutions.
SHUT ENGINE OFF.
NOTE: Allow the track to coast to a
stop. DO NOT apply the brake
because it could produce an inaccu-
rate alignment condition.
4. When the track stops rotating, check
the relationship of the rear idler
wheels and the inner track drive lugs.
If the rear idler wheels are centered
between the inner track drive lugs, no
adjustment is necessary.
5. If the idler wheels are not centered
between the inner track drive lugs,
an adjustment is necessary.
Adjusting Track Alignment
injury
1. On the side of the track which has
the inner track drive lugs closer to
the rear idler wheel, loosen the idler
wheel axle cap screw; then rotate the
adjusting bolt clockwise 1 to 1 1/2
turns.
2. Check track alignment and continue
adjustment until proper alignment is
obtained.
0745-809
0745-811