Handlebar Tilt; Exhaust System - Arctic Cat Jaguar Z1 Operator's Manual

HANDLEBAR TILT

The handlebar can be adjusted to the
operator's preference. To adjust the
handlebar, use the following proce-
dure:
1. Press inward on the lock pin to
release the cam lever and "flip"
the cam lever up.
2. Adjust the handlebar up or
down and/or rotate the handle-
bar to operator's desired posi-
tion; then press down on the
cam lever until the lock pin is
properly positioned and locked.
Check steering for maximum
right/left turning capabilities.
NOTE: At this point, gently lift the
cam lever without pressing in on
the lock pin. If the cam lever can-
not be lifted, the lock pin is secure.
NOTE: Do not rotate the handle-
bar to a position that allows air to
enter the brake system.
3. Test the handlebar to ensure
that it does not rotate within the
riser block. If it does not rotate,
proceed to step 4. If it does
rotate, release the cam lever and
rotate the cam lever clockwise;
then press down on the cam
lever until the lock pin is prop-
erly positioned and locked.
Repeat this procedure until the
handlebar is properly secured.
GENERAL INFORMATION
4. After the handlebar is "locked"
in position, release the cam lever
and rotate it one turn clockwise;
then press down on the cam
lever until it "locks" in place.
NOTE: At this point, gently lift the
cam lever without pressing in on
the lock pin. If the cam lever can-
not be lifted, the lock pin is secure.
! CAUTION
If at any time the lock pin will not
engage into the locked position,
do NOT operate the snowmobile.
Take the snowmobile to an autho-
rized Arctic Cat dealer for service.
! WARNING
Care must be taken to securely
0741-427
lock the handlebar cam lever to
prevent unexpected "move-
ment" of the handlebar during
operation over rough terrain. DO
NOT offset the handlebar so
steering (maximum right/left
turning capabilities) are altered
or throttle and brake controls
will be affected.

EXHAUST SYSTEM

The exhaust system is designed to
reduce noise and to improve the total
performance of the engine. If any
e x h a u s t s y s t e m c o m p o n e n t i s
removed from the engine and the
engine is run, severe engine damage
will result.
9