Code 00 00 00; No Error; Operation - Philips KV-S5055C Service Manual

9.3.

Operation

This section describes each operation (or status indication), according to the function item list shown in Sec.9.2.
9.3.1. Scanner Status
This function indicates the scanner status, and updates it every few seconds. The status messages and their contents are
as follows.
Classification
Code
— Scanner has no error.
U11, U12, U13, A paper jam has occurred.
U14, U16 Open the scanner's door, remove the documents,
and close the door.
Place the documents back in the document feed
tray.
U18 Paper remains in the Scanner.
Open the scanner's door, remove the documents,
and close the door.
Place the documents back in the document feed
tray.
U23 A paper double feed has occurred.
Open the scanner's door, remove the documents,
and close the door.
Place the documents back in the document feed
tray.
U25 A stapled document has been detected.
(Double-feed detection)
Place the documents back in the document feed
tray.
U26 A stapled document has been detected.
(Bent-paper detection)
Place the documents back in the document feed
tray.
U30 Scanner Door is open!
Please close the door.
Fxx System error occurred!
Please consult with a service representative.
— *** Caution***
The rollers need to be cleaned.
Please clean the rollers.
Please select "Clear Counter" button after cleaning
the rollers.
— ***Caution***
The replaceable rollers (consumable) are reaching
the end of their usable life.
To insure reliable operation, please replace these
rollers with Roller Exchange Kit for your specific
scanner.
After replacing the roller, select the "Clear Counter"
button.
*** Caution***
—
The front reference plate may need to be cleaned.
Please clean the front reference plate.
*** Caution***
—
The back reference plate may need to be cleaned.
Please clean the back reference plate.
— Scanner is not connected!
Status Message
89
Contents

No error

U11: Paper Feed Jam (Paper did not reach the
Waiting Sensor.)
U12: Conveyor Jam 1 (Paper did not reach the
Slip Detect Sensor.)
U13: Conveyor Jam 2 (Paper did not reach the
Starting Sensor.)
U14: Conveyor Jam 3 (Paper did not reach the Exit
Sensor.)
U16: Exit Jam 1 (Paper did not pass through the Exit
Sensor.)
Document remains in the scanner, or dust is
attached around a sensor.
Double feed error
The double-feed detection of the stapled document
has been detected.
The bent-paper detection of the stapled document
has been detected.
ADF Door or Imprinter Door is open.
Service level error occurred.
Caution for cleaning rollers.
Caution for replacing rollers.
The reference plate is dirty.
The reference plate is dirty.
Scanner is not connected to PC properly.