Philips KV-S5055C Service Manual page 99

Item
Individual Position 1. Adjust Automatically.
a. Set test chart A (Part No.: See 14.8.) on the Hopper.
b. Click "Individual Position" on the main menu.
c. Click one of 8 "Adjust Automatically" buttons on the
"Individual Position" dialog box to execute the
adjustment.
d. Check the result.
e. Click "OK" to finish the adjustment.
f. Click "OK" to return to the main menu.
2. Adjust Manually.
a. Click "Individual Position" on the main menu.
b. Change the parameter (mm,%) on the "Individual
Position" dialog box as required. (Refer to Remarks.)
c. Click "OK" to renew the setting, and to return to the
main menu.
Operation
99
Default Remarks
— 1. "Adjust Automatically"
a. Length
b. Paper End Position
c. Front Paper Width
d. Front V. Position
e. Front H. Position
f. Back Paper Width
g. Back V. Position
h. Back H. Position
2. Adjust Manually
(Length)
+: Increasing the number
makes the scanning
document length shorter.
(Vertical Position)
+: Increasing the number
makes the document
scanning position shifted
upward.
(Horizontal Position)
+: Increasing the number
makes the document
scanning position shifted
to the left.
(Paper End Position)
+: On the LC (Length
Control) mode,
increasing the number
allows the paper-end
timing to be earlier
(Width)
-: Decreasing the number
extends the scanning
document width.
Note
If the appropriate
scanning position can
not be obtained by any
of the manual
adjustments, check
installation.
.