Bottom Block - Philips KV-S5055C Service Manual

8.2.

Bottom Block

8.2.1. CONTROL Board and DRIVE Board
1. Remove the 8 screws (a) and 2 screws (b) that support the
Cover Plate on the bottom of the scanner.
Then, remove the Cover Plate.
2. Disconnect all connectors (9 connectors and 2 flat cables) on
the CONTROL Board.
3. Remove the 6 screws and the 2 screws with ground lugs on
the CONTROL Board.
Then, remove the CONTROL Board.
4. Disconnect all connectors (8 connectors and 1 flat cable) on
the DRIVE Board.
5. Remove the 2 screws that fasten the Heatsink.
6. Remove the 6 screws on the DRIVE Board.
Then, remove the DRIVE Board.
46