11
SERVICE WORK ON THE CHASSIS
11.20
Removing the seat
11.21
Mounting the seat
(All 250/300 models)
–
Raise the swingarm slightly, and carefully position the shock absorber in the
vehicle from the top.
–
Mount and tighten screw
Guideline
Screw, top shock
absorber
B02100-11
–
Position the angle lever and linkage lever.
–
Mount and tighten screw cap
Guideline
Nut, linkage lever to angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
B02098-11
Finishing work
–
Install the main silencer. (
–
Remove the motorcycle from the lift stand. (
(All 125/150 models)
–
Remove screws
–
Raise the rear of the seat, pull the seat back, and lift it off.
M01156-10
(All 250/300 models)
–
Remove screw
–
Raise the rear of the seat, pull the seat back, and lift it off.
M01188-10
(All 125/150 models)
–
Mount the front seat on to the collar bushing of the fuel tank, lower it at the
rear, and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
M01157-01
.
M10
.
M14x1.5
.
M10
p. 62)
.
.
60 Nm
Loctite
®
2701™
(44.3 lbf ft)
80 Nm (59 lbf ft)
60 Nm
Loctite
®
2701™
(44.3 lbf ft)
p. 44)
56