10
TUNING THE CHASSIS
10.11
Adjusting the riding sag
–
After removing the shock absorber, clean it thoroughly.
Main work
(All 125/150 models)
–
Loosen screw
–
Turn adjusting ring
Hook wrench (T106S)
–
Measure the overall spring length while the spring is not under tension.
–
Tighten the spring by turning adjusting ring
Guideline
Spring preload (125/150 SX EU)
Spring preload (125/150 SX US)
–
Tighten screw
Guideline
Screw, shock absorber adjusting ring
M01133-10
(All 250/300 models)
–
Loosen screw
–
Turn adjusting ring
Hook wrench (T106S)
–
Measure the overall spring length while the spring is not under tension.
–
Tighten the spring by turning adjusting ring
Guideline
Spring preload (250 SX EU)
Spring preload (250 SX US)
Spring preload (All XC models)
–
Tighten screw
Guideline
401025-10
Screw, shock absorber adjusting ring
Finishing work
–
Install the shock absorber.
–
Install the main silencer. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Disassemble the main silencer. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
.
until the spring is no longer under tension.
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
.
.
until the spring is no longer under tension.
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
.
(
p. 54)
p. 62)
p. 61)
(
p. 52)
to measurement
5 mm (0.2 in)
7 mm (0.28 in)
M5
5 Nm (3.7 lbf ft)
to measurement
8 mm (0.31 in)
8 mm (0.31 in)
8 mm (0.31 in)
M5
5 Nm (3.7 lbf ft)
p. 44)
p. 44)
37
.
.