MAINTENANCE WORK ON CHASSIS AND ENGINE
Changing the rear brake linings
9.66
Warning
Skin irritations Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking due to old brake fluid.
–
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
Removing the front wheel
9.67
x
–
Remove the rear brake linings.
–
Stand the vehicle upright.
–
Remove screw cap
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
–
Install the rear brake linings.
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
400233-10
–
Mount the screw cap with the membrane and the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.
x
–
Jack up the motorcycle. (
–
Remove screw
–
Loosen screw
500209-10
–
Remove screws
Info
Do not pull the handbrake lever when the brake calipers are removed.
500208-10
(
p. 45)
x
with membrane
and the O-ring.
(
p. 45)
x
.
p. 82)
p. 21)
.
.
with washers
and take off the brake caliper.
46