Riding Instructions; Checks Before Putting Into Operation; Starting - KTM 450 SMR Owner's Manual

RIDING INSTRUCTIONS

Checks before putting into operation

7.1
Info
Make sure that the motorcycle is in a perfect technical condition before use.
Info
In the interests of riding safety, make a habit of making a general check before you ride.
–
Check the engine oil level. (
–
Check the fuel reserves.
–
Check the chain tension. (
–
Check for chain dirt accumulation. (
–
Check the tire condition. (
–
Checking the tire air pressure. (
–
Check the front brake brake fluid level. (
–
Check the rear brake fluid level. (
–
Check the front brake linings. (
–
Check the rear brake linings. (
–
Check the brake system function.
–
Check the coolant level. (
–
Check the settings of all controls and ensure that they can be operated smoothly.

Starting

7.2
Danger
Danger of poisoning Exhaust gases are poisonous and can result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in a closed
space without an effective exhaust extraction system.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
Info
If the motorcycle is unwilling to start, the cause can be old fuel in the float chamber. The flammable elements of the fuel
evaporate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds until trying again.
Engine has been out of use for more than one week
–
Empty the carburetor float chamber.
–
Turn the handle of the fuel tap to the ON position. (Figure 500178-10

Fuel can flow from the fuel tank to the carburetor.
–
Remove the motorcycle from the stand.
–
Shift gear to neutral.
The engine is cold
–
Pull choke lever out as far as possible.
The engine is hot
–
Pull the hot start lever out to the stop.
–
Press the electric starter button
Info
Do not open the throttle.
The engine is hot and running
–
Push back the hot start lever to the stop with the engine running.
p. 64)
p. 34)
p. 34)
p. 49)
p. 49)
p. 39)
p. 43)
p. 40)
p. 44)
p. 55)
( p. 63)
x
.
p. 11)
15