MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the fork offset
9.25
Removing the fork legs
x
9.26
Installing the fork legs
x
9.27
x
–
Remove the lower triple clamp.
–
Remove screw
–
Rotate the steering stem 180° and insert into the triple clamp. Mount and tighten
screw
Guideline
Screw, bottom steering
head
–
Install the lower triple clamp.
500104-10
–
Remove the front wheel.
–
Remove screws
–
Hang the brake caliper
500200-12
–
Loosen screw
–
Loosen screw
500094-12
–
Position the fork legs.
400248-10
–
Fully tighten screw
Guideline
Screw, top triple clamp
–
Fully tighten screw
Guideline
Screw, bottom triple clamp
500094-11
(
x
. Remove the steering stem.
.
M20x1.5
(
x
(
p. 46)
x
and take off clamp.
and the brake line loosely to the side.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
Info
The topmost sunk nut in the fork leg must be flush to the upper edge of the
upper triple clamp.
Position the bleeder screw
.
.
p. 30)
60 Nm
Loctite
(44.3 lbf ft)
p. 30)
to the front.
M8
17 Nm
(12.5 lbf ft)
M8
12 Nm (8.9 lbf ft)
29
®
243™