MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the rebound damping of the fork
9.17
Info
The hydraulic rebound damping determines the fork suspension behavior.
Bleeding fork legs
9.18
–
Turn adjusting screws
Info
The adjusting screws
Make the same adjustment on both fork legs.
–
Turn back counterclockwise by the number of clicks corresponding to the fork type.
Guideline
Compression damping
500262-10
Standard
Info
Turn clockwise to increase damping, turn counterclockwise to reduce sus-
pension damping.
–
Remove protection covers
–
Turn adjusting screws
Info
The adjusting screws
Make the same adjustment on both fork legs.
–
Turn back counterclockwise by the number of clicks corresponding to the fork type.
Guideline
500189-10
Rebound damping
Standard
Info
Turn clockwise to increase damping, turn counterclockwise to reduce sus-
pension damping.
–
Mount protection covers
–
Jack up the motorcycle. (
–
Remove bleeder screws
Any excess pressure escapes from the interior of the fork.
–
Mount and tighten bleeder screws.
–
Remove the motorcycle from the work stand. (
400248-10
clockwise until they stop.
are located at the top end of the fork legs.
15 clicks
.
clockwise until they stop.
are located at the bottom end of the fork legs.
15 clicks
.
p. 21)
briefly.
p. 21)
26