Kyocera Mita FS-C5016N Operation Manual page 85

3.5 Changing the Interface Parameters
6
Press the key. One of the following menus is indicated. To change settings for the
item, press the ENTER key. Use the
>NetWare
On
>TCP/IP
On
>EtherTalk
Off
>Network Status
Page Off
7
Activate the appropriate protocol that is required to connect the printer to the
network. To activate a protocol, let the protocol displayed, press the ENTER key,
press the or
8
Press the MENU key. The display returns to Ready. You can print a network status
page to confirm that the IP address, subnet mask address, and the gateway address
have been properly set. To print a network status page, see
Interface Status Page on page 3-40
or
Range
Set this item to
>
using NetWare. In submenu (>), frame mode can be
selected from Auto, 802.3, Ethernet II,
802.2, and 802.3SNAP.
Set this item to On when you connect to a network
>
using TCP/IP. Submenu (>) has items including
DHCP, IP address, subnet mask address, and gate-
way address. To resolve IP address for the network
card, see
EtherTalk must be activated (On) for networking
with Macintosh computers.
When the item is set to On, the printer prints out a net-
work status page when it prints the printer status. See
Printing a Network Interface Status Page on page
3-40.
key to change from Off to On, and press the ENTER key.
which follows.
3-38
key to change the value or selection.
On when you connect to a network
3.5.4 Resolving IP Address below.
Printing a Network