Remote Commands And Error Codes - Omega M-4292/1006 User Manual

9.5 Remote Commands and Error Codes

The following tables list all commands, and their descriptions, that
are accepted by the calibrator.
Command
*CLS
*IDN?
*RST
Command
DAMP
DAMP?
DISPLAY
DISPLAY?
FAULT?
ERROR_LOOP
ERROR_LOOP?
ERROR_MODE
ERROR_MODE?
ERROR_PORT
ERROR_PORT?
FUNC
FUNC?
HI_ERR
HI_ERR?
LOCAL
LOCKOUT
LO_ERR
LO_ERR
PRES_UNIT
PRES_UNIT?
REMOTE
Table 5: Common Commands
Description
(Clear status.) Clears the error queue.
Identification query. Returns the manufacturer, model
number, and firmware revision level of the Calibrator.
Resets the calibrator to the power up state.
Table 6: Calibrator Commands
Description
Turns Damp on or off.
Returns if DAMP is on/off
Turns on/off the displays specified in the command
Returns which displays are on/off
Returns the most recent error code
Turns loop power on or off in percent error mode
Returns the current state of loop power in error mode
Turns percent error mode on or off
Returns whether percent error mode is on or off
Set the pressure port for percent error mode
Returns the pressure port for percent error mode
Sets the display mode as specified in the command
Returns the current mode of the upper, middle, and
lower display
Sets the 100% of span limit for percent error mode
Returns the 100% of span limit for percent error mode
Returns user to manual operation of the calibrator
Locks out the keypad of the calibrator in remote opera-
tion
Sets the 0% of span limit for percent error mode
Returns the 0% of span limit for percent error mode
Set the pressure unit for the indicated display
Returns the pressure from the indicated display
Puts the calibrator in remote mode
27