Factory Setups - Omega M-4292/1006 User Manual

Note: The 0% and 100% point will be saved in non-volatile memory
until they are changed again by the user for the internal sensors, and
external pressure modules. When using an external module the 0%
and 100% are set to low and full scale of the module until the user
changes it, or if it was previously saved.

8. Factory Setups

The Calibrator is loaded with five factory setups. These setups are
shown below.
Setup 1: The upper display is set to [P1] mode and the middle is set
Setup 2: The upper display is set to [EXT] mode and the middle is
to mA, lower is off.
set to mA, lower is off.
21