Kenwood SMP06 Instructions Manual page 5

To ensure long life of your Blender,
never run it continuously for longer
than 45 seconds.
Never blend food that has formed
a solid mass during freezing, break
it up before adding to the bottle.
Never blend more than the
maximum capacity (600ml) marked
on the bottle.
When the dispensing lid is fitted
always keep the travel bottle
upright.
care & cleaning
Always switch off, unplug and
dismantle before cleaning.
Never let the power unit, cord or
plug get wet.
Always wash immediately after
use.
Do not let food dry onto the blade
assembly as this will make cleaning
difficult.
Do not wash any part in the
dishwasher.
power unit
Wipe with a damp cloth, then dry.
blade assembly
Unscrew the blade assembly from
the bottle. Then remove the blade
unit by pushing up from
underneath.
Care should be taken when
removing the blade unit from
the blade assembly.
1 Remove and wash the sealing ring.
2 Do not touch the sharp blades -
brush them clean using hot soapy
water, then rinse thoroughly under
the tap. Do not immerse the
blade assembly in water.
3 Leave to dry upside down away
from children.
bottle and dispensing lid
Wash the lid by hand, rinse with
clean water and dry.
service and customer
care
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you experience any problems
with the operation of your
appliance, before requesting
assistance visit
www.kenwoodworld.com.
Please note that your product is
covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the country
where the product was purchased.
If your Kenwood product
malfunctions or you find any
defects, please send it or bring it
to an authorised KENWOOD
Service Centre. To find up to date
details of your nearest authorised
KENWOOD Service centre visit
www.kenwoodworld.com or the
website specific to your Country.
Designed and engineered by
Kenwood in the UK.
Made in China.
5