Front View; Led Indicators; Rear View; Rear Features - OWC MERCURY ELITE PRO DUAL Assembly Manual & User Manual

1.4 Front View

1.4.1 LED Indicators

1. Power — This LED emits a
when the Elite Pro Dual is powered on.
2. LEDs 1 & 2 — These LEDs represent the
two drives inside the Elite Pro Dual. During
normal activity, each of these LEDs will
when the corresponding drive
blink green
is accessed. If one of the drives in the Elite
Pro Dual fails, or if the drive bay is empty,
the corresponding LED will turn
3. Rebuild — If the Elite Pro Dual is set up
as a RAID 1 and one of the hard drives
is being rebuilt, this LED will
during the rebuild process. The LED that
corresponds to the hard drive being rebuilt
will also blink

1.5 Rear view

1.5.1 Rear Features

1. USB 3.1 Gen 1 port — Attach the
included USB 3.1 Gen 1 (Standard-A to
Standard-B) cable here.
2. RAID Dial — Set the RAID mode here.
3. FireWire 800 ports — Attach the included
9-9 pin FireWire 800 cable to one of these
ports and to your computer. Use the other
FireWire 800 port to daisy chain other
FireWire 800 devices.
4. DC IN — Connect the included power
supply here.
5. ON/OFF Switch — Turn power to the Elite
Pro Dual on and off with this switch.
6. Kensington
®
security tether here.
OWC MERCURY ELITE PRO DUAL
solid blue
solid
blink green
green.
Security Slot — Connect a
light
red.
1
1
2
3
4
2
2 3
6
5
INTRODUCTION