OWC MERCURY ELITE PRO DUAL Assembly Manual & User Manual page 10

8. Once you have determined the correct orientation, slide the inner chassis back
into the outer enclosure, as shown below.
9. Once the front grill of the inner chassis sits flush with the edge of the outer
enclosure, turn the Elite Pro Dual on its side again to look at the screw holes on
the bottom. You should see that the screw holes in the outer enclosure line up
with the screw holes in the inner chassis. Use the four smaller screws to fasten
the inner chassis to the outer enclosure, as shown below.
The assembly of the Elite Pro Dual is now complete.
OWC MERCURY ELITE PRO DUAL
8
DEVICE SETUP