CrimeStopper RS2-G3 Installation Instructions Manual page 20

21. TURBO TIMER:
The optional Turbo Timer mode allows the Cool Start system to keep a Turbo or Turbo Diesel vehicle running for 1,
3 or 5 minutes [selectively] after you remove the key and exit the vehicle. This is handy for turbo cool-down without
the need for expensive turbo timers. The Default = OFF.
22 ． TIMED SELF START MODE: Default = OFF
This option allows the system to Self Start every 2, 3 or 4 hours.
23. PINK WIRE SELECTION:
This is a programmable output that has 4 choices;
1. Pink = Brake Reset - Default: This is used for vehicles that have (-) brake pedal switch.
2. Pink = Start Activation Input. This triggers a remote engine start or stop. Connect the Pink wire to an alarm or
keyless entry system with a remote Aux channel to activate the Remote Start by sending a (-) momentary
pulse to the PINK input wire. Other examples would be a GPS Tracker or Smart Phone interface.
3. Pink = Glow Plug Input. Connect the Pink wire to indicator circuit that shows a (-) Signal while the WAIT TO
START LAMP is on. When this wire is used, the system will wait until light turns off before attempting a
remote start.
4. Pink = Handbrake Reset. When this option is selected, the handbrake must be set for remote start. Releasing
the handbrake will Abort Remote Start
24. HYBRID STARTER CRANK TIME:
This option control the Hybrid crank time:
24-1 Starter Crank Time = 4 Seconds – Default
Option 24-2: Same as option 18 setting (0.8, 1.0, 1.2, or 1.4)
25. OPTION RESET: (RESTORE TO DEFAULT)
This option restores all programmable options 1 thru 24 to factory default. The horn will chirp once, the parking light
flash once and all values will be reset to factory original settings.
OPTION DESCRIPTIONS
20