Parking Lights - CrimeStopper RS2-G3 Installation Instructions Manual

WIRING Low Current 14 Pin Plug
WHITE: PARKING LIGHT OUTPUT
RED/BLACK: INPUT SOURCE (12 Volts or Ground)
The Parking Light circuit can be connected up as a high current positive or negative trigger. Connect to vehicle
parking light circuit at the back of light switch or if this is not possible, connect directly to one of the parking lights at
the front of the vehicle. If your vehicle has a multiplex lighting system, that will require a resistor connected in series
with the white wire to the light switch. Use the Negative parking light circuit for Multiplex resistor lights.
Positive Parking Lights
(+)

Parking Lights

(+)
10 AMP
Red/black White
FUSE
(Lights)
12 Volt
Battery
Negative Parking Lights
(-)
Parking Lights
10 AMP
Red/black
FUSE White
(Lights)
Ground
6