Dhcp Relay Parameters; Static Wep Parameters - NETGEAR WG102-500 Reference Manual

WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual

DHCP Relay Parameters

For the "DHCP Server
DHCP Relay Parameters screen displays.
Figure 2-9
The DHCP Server IP field specifies the IP address of the DHCP server

Static WEP Parameters

For the "Security Policy" setting (see
Static WEP Parameters screen displays.
Figure 2-10
The configuration of the static WEP settings enables pre-shared WEP key encryption.
Authentication is not supported by this method. The security level of this method is not very
strong.Table 2-11 shows the DHCP server settings.
Table 2-11. Static WEP Settings
Field
Key Size
Key Format
Configuration
Type" setting (see Table 2-9 on page
Table 2-9 on page
Descriptions
This pulldown menu allows you to make one of the following selections:
• 40 bits (64-bit WEP).
• 104 bits (128-bit WEP).
This pulldown menu allows you to make one of the following selections:
• ASCII.
• HEX.
v1.0, February 2009
2-10), when you select Relay, the
2-10), when you select Static WEP, the
2-13