NETGEAR WG102-500 Reference Manual page 14

WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
LAN: The LAN light on the wireless access point should be blinking green. If it is not,
make sure that the Ethernet cable is securely attached at both ends.
Wi-Fi: The Wi-Fi light on the wireless access point should be blinking green when the
wireless LAN (WLAN) is ready.
6. Configure the wireless access point Ethernet port for LAN access.
• Connect to the wireless access point by opening your browser and entering
http://192.168.0.229 in the address field.
• When prompted, enter admin for the user name and password for the password, both in
lower case letters.
When you are logged in, the following main menu screen displays to facilitate further
configuration of the wireless access point. (For details about the system information
settings, see "System Information" on page
Figure 1-5
1-6
3-6.)
v1.0, February 2009
Introduction and Installation