Reenable The Dhcp Client Of The Access Point - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
6. In the IPv6 Settings section, clear the Link-local Address check box.
The IPv6 address fields display.
7. Specify the static IPv6 address, subnet prefix length, IPv6 gateway address, and
primary and secondary DNS addresses.
8. Click the Save button.
Your settings are saved but not yet applied.
A pop-up window displays. The window shows the number of changes to be applied.
9. In the pop-up window, click the Apply button.
Your changes are applied. If the WiFi link must be reestablished, the page displays
the number of seconds before the access point is back online.
Note: To log back in to the access point, you now must use the IPv6 address that you
assigned.

Reenable the DHCP client of the access point

If you disabled the DHCP client of the access point, you can reenable it, which affects
both the IPv4 and IPv6 settings.
To reenable the DHCP client of the access point:
1. Launch a web browser from a computer or mobile device that is directly connected
over WiFi to the access point or connected to the same network as the access point.
2. Enter the IP address that is assigned to the access point.
If you are directly connected to the "CONFIG-ONLY" SSID, you can enter
https://www.aplogin.net.
A login window displays.
If you do not know the IP address, see Find the IP address of the access point on
page 33. For more information about the "CONFIG-ONLY" SSID, see 2.4 GHz
management SSID on page 58.
If your browser does not display a login window but displays a security message and
does not let you proceed, see Log in to the access point after you complete the initial
log-in process on page 35.
3. Enter the access point local device password and click the Login button.
The local device password is the one that you specified. The password is
case-sensitive.
The Device Status page displays.
Manage the Wired Network
Settings
42 User Manual