Table of Contents
Advertisement
WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
L2TP Tunnel Settings
Figure 2-2
Table 2-2
shows the general access point settings.
Table 2-2. L2TP Tunnel Settings
Field
L2TP Tunnel
L2TP Server Address
L2TP/PPP Username
L2TP/PPP Password
Tunnel IP Address
Tunnel Subnet Mask
Tunnel Management
VLAN
Configuration
Descriptions
Select this check box to start the tunnel establishment from the access point to the
server for centralized traffic management.
The L2TP server IP address for the access point to connect to.
The PPP username for tunnel authentication purpose.
The PPP password for tunnel authentication purpose.
The unique IP address for the wireless access point to communicate over the
tunnel. If you select the From DHCP check box, the IP address of the wireless
access point is then acquired from a DHCP server over the tunnel.
The subnet mask of the wireless access point over the tunnel.
The VLAN from which management sessions are allowed over the tunnel. The
establishment of management sessions is restricted only to the specified VLAN
ID. If the Management VLAN ID is set to zero, no VLAN restriction is applied.
The default value of this setting is zero, which means that no tagging is enabled
(instead of tagged with zero).
v1.0, February 2009
2-3
Advertisement
Table of Contents
