Troubleshooting; No Lights Are Lit On The Wireless Access Point; The Lan Light Is Not Lit; The Wi-Fi (Wlan Activity) Light Is Not Lit During Wireless Activity - NETGEAR WG102-500 Reference Manual

802.11g wireless access point

Hide thumbs Also See for WG102-500:

Reference manual (134 pages)

Installation manual (2 pages)

Table Of Contents

Table of Contents

WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual

Here are some tips for correcting simple problems you may have.

No lights are lit on the wireless access point

The wireless access point has no power:

•

Make sure the power cord is connected to the access point and plugged in to a working power

outlet or power strip.

•

Make sure you are using the correct NETGEAR power adapter supplied with your access

point.

The LAN light is not lit

There is a hardware connection problem:

•

Make sure the cable connectors are securely plugged in at the access point and the network

device (hub, switch, or router).

•

Make sure the connected device is turned on.

The Wi-Fi (WLAN activity) light is not lit during wireless activity

The wireless access point's antennas are not working:

•

If the Wi-Fi light remains off while the wireless access point is transmitting or receiving data,

disconnect the Ethernet cable from PoE switch and then plug it in again.

•

Make sure the antennas are tightly connected to the wireless access point.

•

Contact NETGEAR if the Wi-Fi light remains off while the wireless access point is

transmitting or receiving data.