NETGEAR WG102-500 Reference Manual page 41

WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
Table 3-5 shows the system information settings.
Table 3-5. System Information Settings
Field
General System Information
AP Name
Location
Domain Name
Network IP Address
Network Subnet Mask
Software Versions
Serial Number
Up Time
System Time
Time Zone
Mac Address
L2TP Tunnel Information
Status
Tunnel IP Address
Tunnel Netmask
Firmware/Flash Information
Firmware Version
Flash Status
Boot from
Firmware Upgrade Target
Management
Descriptions
The name of the system entered in the configuration.
The location entered in the configuration.
The domain name used for this system.
The current IP address used on the system.
The current subnet mask used on the system.
The current firmware version running on the system.
The serial number of the device.
The time since the system has booted up.
The time of day in respect to the time zone selected.
The time zone the system is using.
The LAN MAC address of the system.
The status of the L2TP service.
The IP address that is acquired in the established tunnel.
The subnet mask that is acquired in the established tunnel.
The firmware version loaded into the flash partitions.
The firmware status on the flash partitions.
The flash partition from which the system boots up.
The flash partition that is used for a firmware upgrade.
v1.0, February 2009
3-7