Table of Contents
Advertisement
WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
WPA Parameters
For the
"Security
Policy" setting (see
WPA Parameters screen displays.
Figure 2-12
The configuration of WPA parameters enables WPA-TKIP or WPA-AES:CCMP. To enable WPA
and WPA-PSK, configure WPA-TKIP. To enable WPA2 and WPA2-PSK, configure
WPA-AES:CCMP.
When WPA or WPA2 is configured, Radius-based 802.1x authentication with TKIP encryption
method is enabled. With this configuration, the Pre-Shared Key check box should be
disabled.The security level of this method is very strong.
When WPA-PSK or WPA2-PSK is configured, a pre-shared key, or Passphrase, is used for data
encryption and authentication. With this configuration, the Pre-Shared Key check box should be
enabled. The key (passphrase) length must be between 8 and 63 characters, inclusive. The security
level of this method is also very strong.
Access Control
For the
"Access
Control" setting (see
you to control access through MAC address filtering.
Figure 2-13
Configuration
Table 2-9 on page
2-10), when you select WPA, the
Table 2-9 on page
2-10), the Access Control screen allows
v1.0, February 2009
2-15
Advertisement
Table of Contents
