NETGEAR WG102-500 Reference Manual page 11

WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
The following figure shows a rear panel view of the WG102-500, WGAP150:
Figure 1-2
Viewed from left to right, the rear panel of the WG102-500, WGAP150 provides the following:
1. Antenna. An RP-SMA connector for connecting the antenna.
2. LAN Connector. A 10/100BaseT Ethernet connector, normally to be connected to a back haul
network.
3. Reset Button. A reset button to be depressed with a pin. Depress and hold for at lease
5 seconds to restore factory defaults. (For more information, see
Defaults" on page
4. Power Connector. A connector for 5 VDC power input, to be connected with the supplied
power adaptor.
Viewed from left to right, the WG102-500, WGAP150 has these four status LEDs: Power, Status,
Ethernet, and Wi-Fi (also referred to as WLAN light or Wireless activity light):
Table 1-1. Rear Panel LEDs
LED
Power
Status
LAN
Wi-Fi
Introduction and Installation
3-11.)
Description
Off – Power off
On (Green) – Power on
Off – The unit is initializing.
Green – The unit is ready.
Off – The Ethernet port is not connected.
On – The Ethernet port is connected.
Off – Wireless is not ready.
On – Wireless is ready.
v1.0, February 2009
"Restoration of Factory
1-3