Cleaning The Firebox; Cleaning The Smoke Chamber - Piazzetta P963 Instructions For Installation, Use And Maintenance Manual

7.3 CLEANING THE FIREBOX

Once a week clean the fi rebox as follows.
- Remove the grate baffl e.
- Remove the grate.
- Remove the upper baffl e plate extracting it from the front, making a
short turn around the pivot support side.
- Turn the eccentric clamps to free the rear baffl e.
- Lift the baffl e slightly, gripping it by the two outer tabs to free it at the
bottom and then turn it, bringing the bottom outwards, and remove.
- Using a vacuum cleaner remove the ash from the fi rebox.
- After having thoroughly cleaned the fi rebox, remount the internal
baffl e proceeding in the reverse order to above.
- Ensure that the tabs are properly inserted into the relative notches
in the sides of the fi rebox and secure the baffl e by turning the two
eccentric clamps.
- Replace the top baffl e on the provided brackets.
- Replace the grate, pushing it to the rear.
- Replace the grate baffl e.
a
This type of cleaning requires a vacuum cleaner suitable for
holding ash.

7.4 CLEANING THE SMOKE CHAMBER

Once a year clean the smoke chamber as follows:
- remove the screws which secure the smoke chamber cover, then lift it
slightly and take it out by pulling it towards you (Fig. 64 - 65);
- use a vacuum cleaner to remove any ash and carbon deposits which
can accumulate in the chamber, taking care not to damage the blades
of the fan (Fig. 66);
- check the hole on the right side inside the smoke chamber (leading
to the device for measuring the vacuum) for dust and ash and clean
if necessary;
- after thorough cleaning, change the gasket and replace the smoke
chamber closing element.
Fig. 63
ECCENTRIC
CLAMP
Fig. 64
Fig. 65
Fig. 66
H07025410 / DT2000678 – 00
DT2011697-00
UPPER
BAFFLE PLATE
REAR
BAFFLE PLATE
BOTTOM
RESTRAINT
DT2032478-00
DT2010127-02
DT2032950-00
DT2032951-00
DT2032952-00
49