Function Mode - GRAUPNER MX-12 Programming Manual

Function mode

To enter the Function mode, switch the transmitter
power switch to the On position. Press the Down and
Select keys simultaneously, and the display will show
the last active program. Pressing either the Up or Down
key then scrolls through the functions one by one,
according to the Function Mode Flowchart shown below.
Once the appropriate function is displayed, changes can
be made by pressing the (+) or (-) keys. To select ano-
ther channel of a particular function, press the Select
key. The Function mode is the most often used system
to input data.
Function Mode Flowchart
Information pertaining to each function is explained on
the page listed next to the function name. Functions will
appear in the same order they are shown on this chart.
Accessing the Mode Function
1. Move the power switch to the ON position.
2. Press the Down and Select keys simultaneously.
3. Use either the Up or Down to scroll through the
menu and access the applicable function.
16 Function mode
AIRPLANE
1. Dual Rate & EXPonential
2. REVERSING SW
3. SUB TRIM
4. TRAVEL ADJust
5. ELEv Flap MIXing
6. AILe RUDd MIXing
7. THROttle CUT
8. FLAP SYSTEM
9. DIFFERENTIAL
(Only in Wing type)
10. Program MiXing 1
10. Program MiXing 2
10. Program MiXing 3
10. Program MiXing 4
11. FAIL SAFE
(Only in SPCM)
12. Servo Travel Screen
HELICOPTER
13. Dual Rate & EXPonential
14. REVERSING SW
15. SUB TRIM
16. TRAVEL ADJust
17. Swash Mixing
(Over 2 servos in Swashplate type
18. THROttle CUT
19. THROTTLE HOLD
20. THRO Curve
21. PITCH Curve
22. REVOlusion MiXing
23. Program MiXing 1
23. Program MiXing 2
24. FAIL SAFE
(Only in SPCM)
25. Servo Travel Screen