GRAUPNER MX-12 Programming Manual page 32

Function mode HELICOPTER
press the Up key once again until "H" is displayed,
and repeat steps 4 and 5.
8. Access the REVO MX function by pressing the Up
key.
9. Access the THROTTLE CURVE function by pres-
sing the Down key.
10. Exit the PITCH CURVE function by pressing the
Down and Select keys simultaneously.
Output position Graphic display
Point
P-LOW : Full Slow position
P-1 : Stick 1/4 position
P-MID : Stick Center position
P-3 : Stick 3/4 position
P-HIGH : Full High position
* Point position is fixed
Hovering Pitch Lever
The Hovering Pitch lever operates in the same manner
as the Hovering Throttle lever. It is only operable while
the flight mode switch is in the NORMAL position, and
its function is to shift the middle portion of the curve
upward or downward.
Example of Throttle Curve and Pitch Curve Settings
An example of throttle curve and pitch curve settings for
aerobatic specifications is shown below in the form of
graphs. Details of the curves will differ depending on the
helicopter specifications. In these examples, the throttle
open-close stroke and autorotation pitch stroke are set 0
to 100 to ease your understanding of other curves.
32 Function mode HELICOPTER
Throttle
LOW MID HIGH
Throttle
LOW MID HIGH
Pitch
Normal
Hover
LOW MID
Pitch
Stunt 1
Aerobatics
LOW MID
Pitch
Throttle
Hold
LOW MID
(INH)
HIGH
HIGH
HIGH
(INH)