Removing The Central Control Unit - Whirlpool Duet Sport WFW8300SW Instruction Manual

REMOVING THE CENTRAL CONTROL UNIT

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover from the washer
(see page 4-2 for the procedure).
4. Pull the wire connectors off the edges of
the central control unit circuit board (see
the top right photo). When you pull an
edge connector off the board, first pry the
locking tab away from the connector with
a small screwdriver blade to release it.
5. Slide the hooked ends of the two wire
clamps off the locking tabs, and remove
the wires from the clamps.
Central Control Unit
4-4
Central Control Unit Connectors (12)
Wire Clamps
6. Pry up on the locking tab, and push the
central control unit (CCU) toward the
rear of the washer as far as it will go, and
remove the CCU tabs from the keyhole
slots in the chassis.
CCU Locking Tab
Keyhole Slots
Push
CCU Tabs