HPE ProLiant MicroServer Gen8 Quickspecs page 3

QuickSpecs
Standard Features
Storage Controller
Internal Storage Devices Optical Drive
Maximum Internal
Storage
Interfaces
HPE ROM provides for essential initialization and validation of hardware components before control is
passed to the customer-installed operating system. The ROM also provides the capability of booting
from various fixed media (HDD, CD-ROM) and removable media (USB), to continue operation to the
operating system.
HPE ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log
(IML) to assist in diagnosis.
The Hewlett Packard Enterprise ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
Customer-specific BIOS configuration (using the HPE ROM-Based Setup Utility (RBSU).
NOTE: For further information, please refer to The Hewlett Packard Enterprise RBSU (ROM based
setup utility) user guide: http://www.hp.com/support/rbsu.
HPE Dynamic Smart Array B120i Controller
NOTE: HDD bays 1 and 2 support 6.0Gb/s SATA. HDD bays 3 and 4 support 3.0Gb/s SATA.
NOTE: Supports RAID 0/1/10 only. No FBWC support. For FBWC, a standup Smart Array
Controller card must be configured.
NOTE: For more information about the controller and its features, see the HPE Dynamic Smart
Array RAID Controller User Guide on the HPE website:
(http://www.hp.com/support/DSA_RAID_UG_en).
NOTE: To configure arrays, see the Configuring Arrays on HPE Smart Array Controllers Reference
Guide on the HPE website (http://www.hp.com/support/CASAC_RG_en).
NOTE: For general information about HPE Smart Array B120i SATA RAID Controller, please go to:
http://h18004.www1.hp.com/products/servers/proliantstorage/
arraycontrollers/dynamicsmartarray/index.html
Hard Drives
Non-Hot Plug SATA
Video
HPE iLO Remote
Management Network
Port
Micro SD slot
USB 2.0 Ports
Optional: SATA DVD-RW drive
None ship standard
16TB (4 x 4TB) 3.5" SATA
1 Rear standard video
1Gb Dedicated (default iLO4 configuration)
1 Internal
NOTE: The MicroSD slot is not a hot-pluggable device. Customers
should not attempt to plug a MicroSD card into the MicroSD slot while
the server is powered.
5 total (2 front, 2 rear, 1 internal)
HPE ProLiant MicroServer Generation 8 (Gen8)
Page 3