Remoteye Network Card - Toshiba 1600XP SERIES Installation And Operation Manual

18.4 RemotEye Network Card

The RemotEye III and RemotEye 4 are network communication cards for the Toshiba UPS. The RemotEye
communications card is optional for the 1600XP, and standard with the 1600XPi. Both the RemotEye III
and RemotEye 4 will work in either model.
This card slides into a slot located on the back side
network, or LAN-based communication interface for the UPS. When installed, the UPS can be managed
remotely using the common SNMP and HTTP web-based network protocols. The following diagram shows
the flow of the Network Management Station.
18.4.1 To install the RemotEye network card, Follow the
steps below:
1.
Turn the UPS off using the proper shutdown procedure.
2.
Remove the blank cover plate over the extension option
slot.
3.
Slide the RemotEye printed circuit board into the
extension option slot of the UPS.
4.
Secure the printed circuit board using the UPS supplied
screws.
5.
See the RemotEye User Manual, P/N 62330 (RemotEye
III), or P/N 90988 (RemotEye 4), to complete the
hardware setup and software setting for proper
RemotEye operation.
44
(See
NETWORK MANAGEMENT
STATION OR PC WITH
WEB BROWSER
NETWORK ETHERNET BACKBONE
1600XP/XPi Series Installation and Operation Manual – 60616-012
illustration) of the UPS. The card provides a
TOSHIBA UPS
REMOTEYE
NETWORK CARD
RemotEye Card
Mounting Mounting
Screws
REMOTEYE NETWORK CARD LOCATION
Receptacle
Panel
Connector