Hyundai HYT2622-II User Manual page 9

3.3.2. Check the blade guard.
3.3.2.1. The blade guard (A) it WILL NOT protect
against any part of the body coming into contact
with the blades (B).
3.3.2.2. Check the blade guard is not worn or
damaged.
3.3.2.3. Replace the blade guard if it is damaged.
3.4. Check air filter
3.4.1. Check cover is clear of any obstructions and clean before opening.
3.4.2. To check filter loosen the air filter cover screw.
3.4.3. Check the air filter to make sure it is clean and in a good condition.
3.5. Starting.
3.5.1. Press the primer bulb on the carburettor 10 times
before starting from cold and when machine has been
refuelled.
3.5.2. Turn the engine switch to the ON position.
3.5.3. To start a cold engine, move the choke lever to the
START position.
3.5.4. To start the engine, the throttle trigger should be
locked in the fast idling position. To do so, follow the
steps below:
3.5.4.1. Press the throttle trigger lockout (5).
3.5.4.2. Maintaining the throttle trigger lockout
engaged, press the throttle trigger (7).
3.5.4.3. By keeping the two commands (5) and (7) engages, pushed the throttle lock (9).
3.5.4.4. The throttle lock (9) should remain stacked in the down position.
3.5.4.5. Then release the throttle trigger lock out and throttle trigger, the throttle is stuck on
start-up position.
3.5.5. Slowly pull the recoil starter until you feel it engage and then pull it quickly. Return the
recoil starter gently and slowly to the original position by hand.
The cutting attachment may start to move when the engine is started.
Make sure the attachment does not come into contact with any objects.
Make sure that no unauthorised persons are in the working area, otherwise
there is a serious risk of injury.
Page 9
Choke lever
Primer bulb
Rev 2