Hyundai HYT2622-II User Manual page 10

3.5.6. Turn the choke lever to the run positon
3.5.7. After starting the engine, press the throttle trigger to release the throttle trigger lockout. Let
the engine run for 2 to 3 minutes so that it warms up before subjecting it to any load.
3.5.8. DO NOT use the hedge trimmer in the following conditions;
3.5.8.1. When the blades are damaged.
3.5.8.2. In case of engine misfiring.
3.5.8.3. In case of high vibration.
3.5.8.4. If flames or smoke appear.
3.5.8.5. In rain or stormy weather.
3.6. Cutting.
3.6.1. During cutting, keep the running speed high.
3.6.2. Running at low speed for long periods may cause premature wear of the clutch.
3.6.3. On the other hand, the user should not keep the engine speed at maximum speed after
cutting. Any prolonged use at the highest speed is likely to reduce lifetime of engine.
3.6.4. Adjust the throttle setting to suit the load.
3.6.5. When trimming a hedge the engine should always face away from the hedge.
3.6.6. Hold the machine as close to your body as possible to get the best balance.
3.6.7. Make sure that the tip does not touch the ground.
3.6.8. Do not rush the work, but work steadily until all the stems have been cut back cleanly.
When the engine is started for the very first time. It may require a number
of attempts to start.
Check the cutting attachment always stops when the engine is idling.
In an emergency, stop the engine by turning the engine switch to the
'STOP' position.
Trim from sides of hedge first, and then to the top. Cut slowly,
especially with thick hedges.
Page 10
once the engine started.
Rev 2