Hyundai HYT2622-II User Manual page 12

3.6.12. Handle adjustment. (This for the HYT2622-II model only)
3.6.12.1. Proceed as follows;
3.6.12.1.1.
locking knob towards back.
3.6.12.1.2.
3.6.12.1.3.
again.
3.7. Stopping.
When the engine is coming to a stop or power control is released, the cutting
attachment can still cause injury whilst it comes to a stop.
When the unit is turned off, make sure the cutting attachment has stopped before
the setting the unit down.
3.7.1. Decrease engine speed and run at idle for a few minutes.
3.7.2. Switch OFF the engine by moving the engine stop switch to the STOP position.
Do not press the throttle trigger during this operation!
To reduce fatigue when trimming hedges, the rear handle can be
swivelled to 3 positions, left to 90°, or right to 90°.
Release the throttle trigger and throttle trigger lockout, then pull the handle
Turn the rear handle until the handle locking knob clicks into place.
When the rear handle is locked in its new position, the user can start working
To STOP push in
direction of arrow
Page 12
Engine
switch
Rev 2