Hyundai HYT2622-II User Manual page 11

3.6.9. Vertical cutting.
3.6.9.1. Use an arc cutting style from the bottom upwards, then
downwards to use both sides of the blades.
3.6.10. Horizontal cutting.
3.6.10.1. In order to get the best cutting results, slightly tilt the
blade (5-10°) towards the cutting direction.
3.6.11. Kick-back and related warnings'.
3.6.11.1. Kickback is a sudden reaction to a pinched or snagged cutting blade. Pinching or
snagging causes rapid stalling of the rotating accessory which in turn causes the
uncontrolled power tool to be forced in the direction opposite of the accessory's rotation
at the point of the binding. For example, if a blade is snagged or pinched by the stone, the
edge of the blade that is entering into the pinch point can dig into the surface of the
material causing the blade to climb out or kick out. The blade may either jump toward or
away from the operator, depending on direction of the blade's movement at the point of
pinching. Kickback is the result of power tool misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper precautions as given
below.
3.6.11.1.1.
allow you to resist kickback forces.
3.6.11.1.2.
over your hand.
3.6.11.1.3.
occurs. Kickback will propel the tool in direction opposite to the wheel's movement
at the point of snagging.
3.6.11.1.4.
snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag
the rotating accessory and cause loss of control or kickback.
Maintain a firm grip on the power tool and position your body and arm to
Never place your hand near the cutting accessory. Accessory may kickback
Do not position your body in the area where power tool will move if kickback
Use special care when working corners, sharp edges etc. Avoid bouncing and
Page 11 Rev 2