Specifications - Strong SRT 7007 User Manual

No response to remote control
Password forgotten
The external USB HDD does
not start.
The receiver switches to
standby automatically.

9.0 sPECIfICATIons

Demodulator
Demodulation:
Input symbol rate:
FEC decoder:
video Decoder
Profile level:
Input rate:
Aspect ratio:
Video resolution:
Audio Decoder
Audio decoding:
Audio mode:
Sampling rate:
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
Tuner
Type1:
Input frequency range:
RF impedance:
The receiver is off.
The handset is not aimed
correctly.
The IR sensor is obstructed.
The handset batteries are
exhausted.
The default password is 0000
The power consumption is
too high.
The Auto Standby function is
activated and has reached the
set time (default 3h).
QPSK, 8PSK
DVB-S QPSK: 1 ~ 45 Ms/s
DVB-S2 8PSK/QPSK: 10~30 Ms/s
Auto, 1/2, 2/3, 3/4, 5/6, 7/8 in DVB-S mode
1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 in DVB-S2 mode
3/5, 2/3, 3/4, 5/6, 8/9, 9/10 in 8PSK mode
MPEG-2 MP@ML, MP@HL, MPEG-4 H.264/AVC
Max. 20 Mbit/s
16:9 widescreen, Pillarbox, 4:3 Pan&Scan, Letterbox
PAL 50Hz: 576i, 576p, 720p, 1080i, 1080p
NTSC 60Hz: 480i, 480p, 720p, 1080i,1080p
MPEG-1 Layer 1 & 2, AC3, Dolby Digital Down mix, PCM
Mono L/R, Stereo, E-AC3, Dolby Digital, Dolby Digital Plus*
32, 44.1, 48 kHz
F Type, IEC169-24, Female
950 – 2150 MHz
75 Ohm unbalanced
Plug in and turn on the plug.
Aim the handset at the IR
sensor.
Check for obstructions.
Replace the handset batteries.
Contact the local Service
Hotline or send an email to our
support via www.strong.tv
Connect an extra power supply
adapter to your USB HDD
device.
Set the power down time or
disable it in the System Auto
Standby menu .
27