Strong SRT 7007 User Manual page 22

Multi-Transponder Scan:
7.3.1.5 satellite Edit options
Add satellites:
Satellite Name:
Edit satellites:
Delete satellite:
7.3.1.6 Transponder Edit options
note:
Add transponder:
Edit transponder:
Delete transponder:
18
the scan process has been completed, all found channels will be stored and
the receiver will switch to the first found channel.
Select the transponders you want to scan with the ok button. The selected
transponders will be marked with the z symbol. Press bLuE for Scan. A
window with scan settings will be displayed. After configuring the settings
like explained in 7.3.1.2 above, press ok or bLuE again to start Multi-Scan on
all selected transponders.
Press rED to add a new satellite. In the pop-up banner, enter the satellite's
name and position by using the p/q tu and 0 ~ 9 buttons.
Press ok to enter text input mode. In the key table select a character by using
the navigation buttons. Press ok to enter the chosen character. When you
have entered the name, navigate to the "OK" button on screen and press ok
on the remote control to confirm the new name. Save the settings with ok or
cancel by .
Press GrEEn to edit the focused satellite. For changing settings see
explanation above. Confirm changes with ok or cancel by .
Press YELLoW to delete the focused satellite. Press ok to confirm deleting or
 to cancel.
Transponders can only be edited when the transponder list is on screen. To
do this, select the satellite you want to edit and press 4 to open the TP list.
The options below are now available.
Press rED to add a new transponder. In the pop-up banner, enter the
transponder´s data by using the p/q tu and 0 ~ 9 buttons. Confirm the
settings with ok or cancel with . An existing TP cannot be stored again
under the same satellite.
Press GrEEn to edit the highlighted transponder. In the pop-up banner,
change the transponder´s data by using the navigation and numeric buttons.
Confirm changes with ok or cancel with .
Press YELLoW to delete the highlighted transponder. Press ok to confirm or
 to cancel.