Areas Of Application - FLORABEST FTP 400 A1 Translation Of Original Operation Manual

the pump in garden ponds with fish
stocks or valuable plants.
• Pollution of the liquid could occur due
to leakage of lubricants
• Do not carry or fix the equipment by the
cable or pressure line.
• Protect the equipment from frost and
from running dry.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Please read the notes in the operating
instructions on the topic of "mainte-
nance and cleaning". Any measures
above and beyond these, particularly
opening the equipment, are to be car-
ried out by an electrician. In the case
of repairs, always contact our service
centre.
Electrical safety:
Caution: to avoid accidents and inju-
ries from electric shocks:
• After erection, the mains plug must be
freely accessible when the equipment
is in operation.
• Before operating your new pump, have
a specialist check:
- The earthing, the protective mul-
tiple earthing; the residual current
circuit breaking must be compliant
with the safety regulations of the
energy supply company and func-
tion without fault.
- The protection of the electrical plug
connections from the wet.
- If there is a risk of flooding, fix the
plug connections in an area that is
safe from flooding.
• Ensure that the mains voltage matches
the specifications on the rating plate.
• The electrical installation shall be ac-
cording to national wiring rules.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA.
Fuse: at least 6 ampere.
• Before each use, check the equipment,
cable and plug for damage.
• If the supply cord is damaged, it must
be replaced by the manufacture or its
service agent or a similarly qualified
person in order to avoid a hazard.
The supply cord must be 10 m long.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or fix the equipment by the
cable.
• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Before any work on the equipment, dur-
ing work breaks and in the case of non-
use, remove the plug from the socket.

Areas of Application

The immersion pump acquired by you is
designed for pumping water with a maxi-
mum temperature of 35°C.
This pump can be very suitably used as a
basement pump. However, it can also be
used in every case where water must be
pumped, for example in the household,
in agriculture, in horticulture, in sanitation
work and in many other applications.
The operator or user is responsible for ac-
cidents or damage to other people or their
property. The manufacturer shall not be li-
able for damages caused by use other than
for which the equipment is intended or by
incorrect operation.
GB CY
7