Table of Contents
Advertisement
Low Water Tank Heat Protection Check
1.
Open the drain valve on the wash tank.
2.
Pumps and conveyor stop when the water level falls below the level
of
the
wash tank float switch.
3. Close the drain valve.
4.
Open the manual fill valve and refill the wash tank.
5.
Push the green start button on the control cabinet.
Pumps and conveyor run.
6.
Repeat Steps 1-5 for the power rinse tank.
Conveyor Jam Switch Check
Refer to Figure 3.3 below
WARN
IN G :
The conveyor drive contains moving parts.
Use caution when working
around
the conveyor drive assembly.
1. Using a hydraulic jack or lever,raise the conveyor drive table (A) approximately
2 inches to simulate a jam condition.
2. The conveyor jam switch
(B)
operates.
3. Pumps and conveyor stop.
4.
Lower the conveyor drive table.
5.
Push the green start button on the control cabinet.
Pumps and conveyor run.
Figure 3.3
Conveyor Jam
Switch Check
I
(Right
to
left model shown)
26
Advertisement
Table of Contents
