Quantum scalar i40 Quick Start Manual page 9

Figure 6 Turning on the Library
Figure 7 Setup Wizard – Initial
Screen
Turning the Library ON and Configuring Network Settings
When initialization completes, the Setup Wizard screen appears on the operator
panel (see Figure 7). The operator panel screen contains a menu bar with operations
that correspond to the four physical buttons below it. The menu operations and
button functions change with each screen.
2 Before proceeding, verify the Ethernet cable is connected and all of your tape drives
are installed.
3 Do one of the following:
• To configure basic network settings using the Setup Wizard, press the button
corresponding to Next on the menu bar. You will be guided through a series of
screens where you can accept or change the default configuration settings
(date, time, IP address, licenses, partitions, I/E station slots, and cleaning slots).
Once you accept a setting, you move to the next one. Remember that you can
always change the configuration later if needed.
• To cancel out of the Setup Wizard and begin using the library immediately, press
the button corresponding to Cancel on the menu bar. This accepts the library's
default configuration, including an IPv4 address assigned by DHCP. The Setup
Wizard will not appear on the operator panel again, but you can change any of
the configuration settings later using the Setup menus on the operator panel or
the Web client. It is easier to configure the library using the Web client, so you
may wish to cancel now. To access the Web client immediately, skip the rest of
this section and go to
Power
button
Menu bar
Navigation/selection
buttons
Accessing the Library Via the Web Client
Scalar i40 and Scalar i80
Power LED
on page 13.
9