Quantum scalar i40 Quick Start Manual page 11

Figure 10 Setup Wizard –
Setup Network Screen
Figure 11 Setup Wizard –
Licenses Screen
Turning the Library ON and Configuring Network Settings
The Setup Network screen appears, listing a default host name (which you cannot
change here but you can change later on the Web client) and an IPv4 address
assigned by DHCP (see
5 Do one of the following:
• To accept the IP address, press the Accept button.
• To change the IP address, press the Change button. Complete the network
configuration screens and press Accept when finished.
• If you accept IPv4 as the protocol, you can choose to get an IP address via
DHCP or enter a static IP address. If you choose DHCP, the IP address, mask,
and gateway are displayed. If you choose not to use DHCP, use the
directional buttons as described in
address, mask, and gateway.
• If you choose IPv6 as the protocol, the library supplies a stateless IPv6
address and displays it, along with other network settings, on two screens.
Use the Next and Back buttons to view the screens. You can only change
these settings via the Web client.
The Current Licenses screen appears, which lists the number of licensed and
unlicensed slots in the library and the licenses currently installed (see
You may have received, separately, License Key Certificates containing instructions
on how to retrieve your desired license key from the Quantum Web site.
6 Once you have retrieved your license key, you may add it now or any time later. (If
you did not receive your License Key Certificate, contact the place of purchase.)
Figure 10).
Step
Scalar i40 and Scalar i80
on page 10 to enter a static IP
Figure 11).
11