Quantum scalar i40 Quick Start Manual page 16

Scalar i40 and Scalar i80 Quick Start Guide
16
To import tape cartridges:
1 Unlock the I/E station.
a From the operator panel, press the Actions button, then press the Down button
to select I/E, then press Select.
b Select Unlock I/E Station and press the Select button.
c If the library contains more than one I/E station, select an I/E station and press
Unlock.
The robot moves to the I/E station and unlocks it.
2 When the operator panel display prompts you, pull out on the magazine door until
it stops. If you wait more than 30 seconds, the I/E station re-locks.
3 Insert tape cartridges into the I/E station slots. Make sure the cartridges are properly
labeled and right-side-up.
Note: All tape cartridges must have a unique, external barcode label that is
machine readable. Quantum-supplied barcode labels provide the best
results (labels are packaged along with your library). Barcode labels
supplied by other sources can be used, but they must meet specific
requirements (for details, see the "Barcode Requirements" section of the
Scalar i40 and Scalar i80 User's Guide
4 Close the magazine by pushing it in until it stops.
The robot move to the I/E station and scans the newly installed tape cartridges.
When finished, the operator panel asks you to assign the cartridges to a partition.
5 Assign the cartridges to a partition. Use the Up and Down buttons to select a
partition, then press the Apply button.
Note: You must assign all the newly installed tape cartridges to the same
partition. If you want to assign them to different partitions, you need to
disable manual cartridge assignment and use the Web client. See the
i40 and Scalar i80 User's Guide
6 Import the tape cartridges.
a Press the Down button to select I/E and press the Select button.
b Press the Down button to select Import Tape and press the Select button.
c Use the Up and Down buttons to select a single tape cartridge or ALL tape
cartridges and press the Import button. (The ALL option is only available if there
are enough empty slots in the selected partition to accommodate all the
cartridges.)
The robot imports the tape cartridge(s) into the partition you selected.
d When the operator displays an "import complete" message, press the OK
button.
e Repeat steps a through c for any remaining tape cartridges in the I/E station.
7 Repeat the above steps until all your tape cartridges are imported.
).
for details.
Importing Tape Cartridges
Scalar