Lan - Novatel MIFI M100 User Manual

LAN

The LAN section of the Advanced Settings page gives you settings and information about the
MiFi M100's network. The LAN menu contains the following settings:
IPv4
•
IP Address — The IP address for the MiFi M100.
•
Subnet Mask — The subnet mask network setting for the MiFi M100. The default value
•
255.255.255.0 is standard for small (class "C") networks. If you change the LAN IP Address,
ensure you use the correct Subnet Mask for the IP address range containing the LAN IP
address.
MAC Address — The Media Access Controller (MAC) or physical address for the MiFi M100.
•
Turn on DHCP server — Enables or disables the DHCP Server feature. Normally this should
•
be left turned on.
Start DHCP address range at — The start range of IP addresses reserved for use by the
•
MiFi M100's DHCP server table.
DHCP address range — The current range of IP addresses reserved for use by MiFi M100's
•
DHCP server table. If a device with a static IP address wants to connect to MiFi M100's
network, the static IP should be outside of the DHCP address range. Most devices do not
have a static IP.
DHCP lease time — Use to determine how often connected devices must renew the IP
•
address assigned to them by the DHCP server. Normally this is left at the default value,
but if you have special requirements you can change the value.
IPv6
•
Turn on IPv6 — Turns ON/OFF the IPv6 feature.
•
Link-Local address — Displays the local address when IPv6 is turned on.
•
Save Changes — Use to activate and save new settings.
•
Settings > Advanced Settings > LAN
42