LifeSpan TR5000i Owner's Manual page 26

Assembling Your Treadmill
Step 1: Unpacking Treadmill
A. Cut packaging straps and
remove.
B. Remove the box top.
C. Remove small parts and
packaging material and
unwrap parts.
D. Cut the corners of the
bottom box and remove all packaging material to begin assembly. The
treadmill can be assembled in the box. No need to pick the treadmill up
to remove it from box.
Step 2: Upright Post Assembly
A. Carefully raise the upright
posts and handlebar assembly.
B. Carefully lay handlebars down
as the uprights are brought
up into position. This will
protect against any accidental
damage to wires coming up
through the upright into the
handlebars.
C. Align the holes in the lower
portion of the upright with
the threaded holes in the
frame.
D. Install the four M10 x 55L
bolts (9) and M10 washers
(10), two in each upright. The
best way to handle this is to
loosely install all four bolts
and washers and then tighten
once all bolts are installed.
24
6mm Allen
M10 x 55L M10 Washer
(x4)
Support
handlebars
as you lift
Wrench
(x4)